Sartorius LMA 200PM Microwave Moisture/Solid [Reconditioned]

Description

Sartorius Microwave LMA 200 PM [reconditioned]
Description:
Sartorius Microwave Moisture/Solids analyzer
Dries in approximately 40 to 120 seconds.
Easy-to-operate
Improve process control
Easy to clean and disinfect
Increase profits
Rugged and durable
Precise measurement of liquids, solids, slurries, fat (when used with
CEM Fat Extractor
), High volatiles Dilution, total suspended solids (TSS) and bias Syringe weighing
Low-noise thermal printer
Printer (external) Optional
Touch screen keys
Stores up to 320 drying programs
There are three modes to choose from for analysis
There are two modes to choose from for operation of the microwave
Specifications:
Measurement method: Sample heated by microwave radiation; moisture content calculated from loss on drying
Microwave generator: 1000 W
Power output: 2% to 100%, configurable in 1%-steps
Measurement range: 8% to 100%
Accuracy: From 1 g initial sample weight +/– 0.05%
Response time: Approximately 40 to 120 seconds (depends on sample and moisture content)
Display of results: % moisture content with calculation options; ppm moisture content,
% volatile components, %, ppm solids, g solids, mg solids, % ratio
Weighing capacity: 70 g
Resolution|reading accuracy of the weighing system: 0.1mg
Reading accuracy of the measurement results: 0.001%
Display module: 1/4 VGA
Control elements: Touchscreen, 5 function keys
Program memory: 320 drying programs with alphanumeric designation
Data storage: The 500 most recent results, with statistical evaluation, stored in battery-backed memory
Built-in printer: Thermal printer, 40 characters per line
Data interfaces: 1 serial RS-232 interface, 1 Ethernet port
Pollution degree 2: Normally only nonconductive pollution or temporary conductivity caused by condensation.
Limitation of emissions: In accordance with EN 61326-1 (IEC 61326-1):
Group 1, Class B, suitable for use in domestic establishments and establishments
directly connected to a low-voltage power-supply network that supplies buildings used for domestic purposes.
Immunity to interference: In accordance with EN 61326-1, (IEC-1 ):
Immunity test requirements for equipment intended for use in industrial locations (Table 2)
Electrical safety: In accordance with EN 61010-1 (IEC 61010-1)
Electrical Requirement:
Dimensions: (H + W + D) 304 + 510 + 535 mm (12 + 20 + 21 in.)
Weight: Approximately 22 kg (48.4 lbs)
Power source: 230 V, 50 Hz, 1200 VA (LMA200PM-000EU)
115 V, 60 Hz, 1200 VA (LMA200PM-000US)
Fuse: 2 + 10 A/T (5 + 20 mm)